Filter
Top Products
Network Tools
HSIM-W87 User’s Guide 4-5
The Network Tools functions are performed using a series of commands.
Entering commands in Network Tools involves typing the command at the
Network Tools prompt, adding any required parameters, and pressing
ENTER to execute the command.
There are two categories of commands in the command set.
• Built-in Commands – Allow the user to access and manage network
devices. The commands for the HSIM-W87 are imux, ds1alarm,
wanpq, dsx1, and dsx3. The other commands listed in Figure 4-2 are
described in the host platform manual.
• Special Commands – Allow the user to exit from Network Tools. The
commands are done, exit, and quit. All three commands perform the
exact same function.
The commands are presented in the following format:
command:
Syntax: Shows the required command format. It indicates where
arguments, if any, must be specified.
Description: Briefly describes the command and its uses.
Options: Lists any additional fields in the appropriate format that
may be added to the command.
Example: Shows an example of how to use the command.
NOTE
The conventions used in describing the commands in Network
Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by
the user is shown in bold Helvetica font.
To abort the output or interrupt a process, press the CONTROL
key and c key simultaneously, designated as ^C here.