Filter
Top Products
Chapter 2: Installation
2-6 HSIM-W87 User’s Guide
8. Press down firmly on the HSIM-W87 until the connector slides all the
way onto the HSIM pins. Ensure that the standoffs on the standalone
device align with the standoff screw holes on the HSIM-W87.
9. Secure the HSIM-W87 to the module faceplate using the mounting
screws saved in Step 5.
10. Secure the HSIM-W87 to the module standoffs using the standoff
screws included in the HSIM-W87 shipping materials.
11. Replace the chassis cover on the standalone device, reconnect the
power cord, and reconnect the standalone device to the network.
2.3 CONNECTING THE HSIM-W87 TO THE NETWORK
The HSIM-W87 is connected to the carrier’s DS3 service using coaxial
cable. The 75 Ohm unbalanced coaxial cable may be run a maximum of
450 feet. For typical configurations for the HSIM-W87, see Appendix B.
2.4 HSIM-W87 SETUP
See Chapter 3 for information on the LEDs, Chapter 4 on how to set up
the HSIM-W87 in management, and Chapter 5 for Troubleshooting.
!
CAUTION
Ensure that the HSIM-W87 connector aligns with the device
connector pins to prevent bending the pins. This can damage
both the HSIM-W87 and the device.
Ensure that the chassis cover is in place before reconnecting
the power cord.