Filter
Top Products
8
SSIM-H2-02 Fast Ethernet - Translational Switch SmartStack Interface Module Installation and User Guide Installation
4. Carefully insert the module into the rails on each side of the expansion slot,
sliding it back until the connector on the module is seated into the connector at
the back of the slot. See Figure 3. When the module is fully seated, the module
faceplate will be flush with the front of the base switch.
Figure 3. Installing the SSIM-H2-02
5. Secure the module with the two attached thumb screws.
6. Re-apply power to the switch.
Software Installation
Before you can use your SSIM-H2-02, you have to install the module software
image. The software image can be downloaded to the module via TFTP or via a
serial line. Search the disks supplied with the module for a file named FEyyzz.BIN.
The letters yyzz in the file name represent the version number of the software. For
example, FE0310.BIN is version 3.10 of the software image.
TFTP Download
1. Copy the software image to a suitable directory on the TFTP server.
2. Set-up VLAN IP configuration on the VLAN which will be used to download.
3. From the main menu in the console, select
Download→
→→
→Upload
.
4. Select
TFTP Download→
→→
→Upload
.
5. Set the IP address of the TFTP server. Also, set the download VLAN (the BRF
which will be used to perform the download).
6. Select
TS Firmware Download
.
7. Select
TS Firmware Download Filename
and type the file name of the
software image to download.
8. Select
Execute TS Image Network Download
to start the download.