Canon IR3300 Copier User Manual


 
COPYRIGHT
©
2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 5 SERVICE MODE
5-38 T
<SORTER (4/8)>
3.5.2 Saddle Finisher-G1
Address
bit
Notation
Description Remarks
P001 0 M4 front aligning plate motor phase A output 0: ON
(output)
1 M4 front aligning plate motor phase B output 0: ON
2 M8 slide moor phase A output 0: ON
3 M8 slide motor phase B output 0: ON
4 M3 delivery motor phase A output 0: ON
5 M3 delivery motor phase A* output 1: ON
6 M3 delivery motor phase B output 0: ON
7 M3 delivery motor phase B* output 1: ON
P002 0 M2 paddle motor phase A output 0: ON
(output)
1 M2 paddle motor phase A* output 1: ON
2 M2 paddle motor phase B output 0: ON
3 M2 paddle motor phase B* output 1: ON
4 M6 shift motor UP drive output -
5 M6 shift motor DOWN drive output -
6 M7 bind motor PWM output 0: ON
7 M7 bind motor clock sensor input 0: ON
P003 0 puncher unit transmission signal (output)
1 commercial device TXD (output)
2 puncher unit reception signal (input)
3 commercial device RXD (input)
4 PI24 full stack sensor (full detection) 1: FULL
5 CL1 bind clutch 1: ON
6-7 not used
P004 0 not used
(input) 1 push switch 1, 2 -
2 DIP switch 7, 8 -
3 DIP switch 5, 6 -
4 DIP switch 3, 4 -
5 DIP switch 1, 2 -
6 PI10 fold position sensor light emission (output) -
7 PI10 fold position sensor (analog) -
P005 0 EEPROM chip select 1: selected
(output)
1 EEPROM/DA clock output (used in common) -
2 EEPROM/DA data output (used in common) -
3 DA load signal output (used in common) 1: load
4-7 not used
COPIER>I/O>SORTER