Filter
Top Products
The machine is not ready. Check if the Power lamp is lit green.
If the Power tamp is off, turn the machine on.
While the Power tamp is flashing green, the machine is initializing. Wait until the
Power lamp stops flashing and remains tit green.
Note
When printing large data such as a photo or graphics, it may take longer to start
printing.
Paper Does Not Feed Properly
Printing on inappropriate type of paper.
Paper Feed Rollers are dirty.
Paper not loaded properly.
Too much paperloaded.
Foreign object inthe Rear Tray.
Envelopes not prepared nor loaded
properly.
Check to see if the paper you are printing on is not too thick or curled.
See "Media Types You Cannot Use" on page 14.
Clean the Paper Feed Rollers. Cleaning the Paper Feed Rollers will wear the
rollers, so perform this procedure only when necessary.
For details on cleaning, see "Cleaning the Paper Feed Roller (Roller cleaning)"
on page 53.
Make sure of the following when you toad paper in the machine.
• When loading two or more sheets of paper, align the edges of the sheets
before loading.
• Always toad the paper in portrait orientation in the Rear Tray, regardless of
the printing orientation.
• Load the paper with the print side facing UR Align the paper stack against
the right side of the Rear Tray and slide the Paper Guide so that it just
touches the left edge of the stack.
For details on loading paper, see "Loading Paper" on page 15.
Make sure that the paper stack does not exceed the toad limit.
However, proper feeding of paper may not be possible at this maximum capacity
depending on the type of paper or environmental conditions (either very high or
tow temperature and humidity).
In such cases, reduce the sheets of paper you toad at a time to around half.
For details on loading paper, see "Loading Paper" on page 15.
Make sure that there are no foreign objects in the Rear Tray.
• When printing on envelopes, see "Loading Envelopes" on page 17, and
prepare the envelopes before printing.
Once you have prepared the envelopes, load them in the machine in portrait
orientation. If the envelopes are placed in landscape orientation, they will not
feed properly.
• Set the Paper Thickness Lever to the right.
66 Troubleshooting