Filter
Top Products
17-47
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E157 Disable Alarm Filtering
DLP-E157 Disable Alarm Filtering
Step 1 In the node, network, or card view, click the Alarms tab.
Step 2 Click the Filter tool at the lower-right side of the bottom toolbar.
Alarm filtering is enabled if the tool is selected and disabled if the tool is raised (not selected).
Step 3 If you want alarm filtering disabled when you view conditions, click the Conditions tab and repeat
Step 2.
Step 4 If you want alarm filtering disabled when you view alarm history, click the History tab and repeat
Step 2.
Step 5 Return to your originating procedure (NTP).
DLP-E158 Manually Lock or Unlock a User on a Single Node
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 Choose the user you want to lock out.
Step 3 Click Change.
Step 4 Complete one of the following:
• To lock a user out so the user cannot log into the node, check the Locked out check box.
• If the user is currently locked out, uncheck the Locked out check box.
See the “DLP-E130 Change Security Policy on a Single Node” task on page 17-26 for more
information about manual lockouts and lockout duration.
Step 5 Click OK. A confirmation dialog box appears.
Purpose This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.
Tools/Equipment None
Prerequisite Procedures DLP-E155 Enable Alarm Filtering, page 17-44
DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote
Onsite or remote
Security Level
Retrieve or higher
Purpose This task manually locks out or unlocks a user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser