Filter
Top Products
17-76
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E198 Delete a Section DCC Termination
• Far End is Foreign—Check this box to specify that the LDCC termination is a non-ONS node.
• Far end IP—If you checked the Far End is Foreign check box, type the IP address of the far-end node
or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the far
end.
Step 5 Click OK.
Step 6 Return to your originating procedure (NTP).
DLP-E198 Delete a Section DCC Termination
Step 1 Click the Provisioning > Comm Channel > SDCC tabs.
Step 2 Click the SDCC termination to be deleted and click Delete. The Delete SDCC Termination dialog box
appears.
Step 3 Click Ye s in the confirmation dialog box. Confirm that the changes appear; if not, repeat the task.
Step 4 Return to your originating procedure (NTP).
DLP-E199 Delete a Line DCC Termination
Caution Deleting a DCC termination can cause you to lose visibility of nodes that do not have other DCCs or
network connections to the CTC computer.
Step 1 Click the Provisioning > Comm Channel > LDCC tabs.
Step 2 Click the LDCC termination to be deleted and click Delete. The Delete LDCC Termination dialog box
appears.
Step 3 Click Ye s in the confirmation dialog box. Confirm that the changes appear; if not, repeat the task.
Purpose This task deletes a SONET Section DCC termination.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task deletes a SONET Line DCC termination.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher