Cisco Systems 200 Switch User Manual


 
IP Configuration
Domain Name
243 Cisco Small Business 200 Series Smart Switch Administration Guide
16
-
OK
—Attempt succeeded.
-
Negative Cache
—Attempt failed, do not try again.
-
No Response
—There was no response, but system can try again in
future.
TTL— If this is a dynamic entry, how long will it remain in the cache.
Remaining TTL— If this is a dynamic entry, how much longer will it remain in
the cache.
STEP 3 To add a host mapping, click Add.
STEP 4 Enter the parameters.
IP Version—Select Version 6 for IPv6 or Version 4 for IPv4.
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
Link Local Interface—If the IPv6 address type is Link Local, select the
interface through which it is received.
Host Name—Enter a user-defined host name or fully-qualified name. Host
names are restricted to the ASCII letters A through Z (case-insensitive), the
digits 0 through 9, the underscore and the hyphen. A period (.) is used to
separate labels.
IP Address(es)—Enter a single address or up to eight associated IP
addresses (IPv4 or IPv6).