Filter
Top Products
Administration: File Management
DHCP Auto Configuration
Cisco Small Business 200 Series Smart Switch Administration Guide 52
4
STEP 3 Enter the following optional information to be used if no configuration file name
was received from the DHCP server.
• Backup Server Definition—Select By IP address or By name to configure
the server.
• IP Version—Select whether an IPv4 or an IPv6 address is used.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—Select the link local interface (if IPv6 is used) from the
list.
• Backup Server IP Address/Name—Enter the IP address or the name of the
server to be used if no server IP address was specified in the DHCP
message.
• Backup Configuration File Name—Enter the path and file name of the file to
be used if no configuration file name was specified in the DHCP message.
STEP 4 Click Apply. The parameters are copied to the Running Configuration file.