Filter
Top Products
31
Management Interface DHCP Server IP Address Enter the management interface DHCP server IP
address.
Virtual Gateway IP Address Enter the IP address of the controller virtual
interface. You should enter a fictitious,
unassigned IP
address, such as 1.1.1.1.
The virtual interface is used to support mobility
management, DHCP relay, and embedded Layer
3 security such as guest web authentication and
VPN termination. All controllers within a
mobility group must be configured with the same
virtual interface IP address.
Mobility/RF Group Name If desired, enter the name of the mobility
group/RF group to which you want the controller
to belong.
Although the name that you enter here is assigned
to both the mobility group and the RF group,
these groups are not identical. Both groups define
clusters of controllers, but they have different
purposes. All of the controllers in an RF group
are usually also in the same mobility group and
vice versa. However, a mobility group facilitates
scalable, system-wide mobility and controller
redundancy while an RF group facilitates
scalable, system-wide dynamic RF management.
Network Name (SSID) Enter the network name, or service set identifier
(SSID). This is the default SSID that the access
points use when they join a controller.
Configure DHCP Bridging Mode Enter yes to configure DHCP Bridging Mode.
Values are yes or no. The following message
appears:
Warning! The default WLAN security policy
requires a RADIUS server. Please see
documentation for more details.
Table 3 Startup Wizard Information (continued)
Wizard Setting Action