Filter
Top Products
33
5 Logging into the Controller
To log into the 2504 controller, follow these steps:
Step 1 Enter a valid username and password to log into the controller CLI.
Note The administrative username and password you created in the startup wizard are case
sensitive.
Enter a polling interval between 3600 and
604800 secs
Enter the polling interval between 3600 and
604800 seconds.
Note This prompt only displays if YES was
entered in the “Configure a NTP Server
Now?” prompt.
Configuration correct? Enter yes if the configuration entered is correct.
Values are yes and no. If yes is entered. the
controller saves your configuration, reboots, and
prompts you to log in.
Table 3 Startup Wizard Information (continued)
Wizard Setting Action