Filter
Top Products
36
Figure 14 Access Points Connected to a Controller
Checking the Controller LEDs
If your 2504 controller is not working properly, check the LEDs on the front panel of the unit. You
can use the LED indications to quickly assess the status of the unit. See
Table 1 on page 5 for a
description of the front panel LEDs.
The installation is complete. Refer to the Cisco Wireless Controller Configuration Guide for more
information about configuring your controller. The guide is available on cisco.com.
Using the Reset Button
The Reset button on the front panel of the controller becomes active after the controller boots. To reset
the controller using the Reset button, follow these steps:
Step 1 Connect a PC to the controller console point.
282081
10/100/1000BASE-T
MDI cables
10/100/1000BASE-T
MDI cable
Cisco Access Points
Network
C
isco 2504 Wireless
Controller
Network