Filter
Top Products
76-23
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 76 Configuring Logging
Monitoring the Logs
Editing the Rate Limit for a Syslog Severity Level
To change the rate limit of a specified syslog severity level, perform the following steps:
Step 1 Enter the maximum number of messages at this severity level that can be sent.
Step 2 Enter the amount of time, in seconds, that is used to limit the rate of messages at this severity level, and
click OK.
The selected message severity level appears.
Note To allow an unlimited number of messages, leave both the Number of Messages and Time
Interval fields blank.
Monitoring the Logs
This section includes the following topics:
• Filtering Syslog Messages Through the Log Viewers, page 76-24
• Editing Filtering Settings, page 76-26
• Executing Certain Commands Using the Log Viewers, page 76-26