Filter
Top Products
3-32
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
c. Replace the PCIe riser card assembly.
See the “Replacing a PCIe Riser Card Assembly” section on page 3-33 for instructions.
d. Replace the top cover.
e. Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the Power button. See the following note.
Note The TPM must be activated in the BIOS before you can use it. If you have not already activated the TPM
in the BIOS, proceed with the following step.
Figure 3-20 Removing and Replacing a TPM
Step 3
Activate the TPM in the server BIOS:
a. Either attach a VGA monitor and USB keyboard to the server, or log in remotely to the CIMC
interface of the server and open a virtual KVM console window. For instructions on using the CIMC,
refer to the Cisco UCS C-Series Rack-Mount Server Configuration Guide.
b. Reboot the server.
Note You can reboot the server by pressing the Power button on the server; by selecting
Macros > Ctrl-Alt-Del on the Cisco KVM Console window menu bar; or by selecting Power Cycle
Server on the Server Summary tab of the CIMC GUI.
c. Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
d. If you have already configured a BIOS Administrator password, enter it and skip to Step h.
e. If you have not set a BIOS Administrator password for the server, continue with this step.
On the BIOS utility screen, select the Security tab, then select Set Administrator Password. Use
the pop-up boxes to set the BIOS administrator password, then press F10 to save your settings and
reboot the server.
f. Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
g. Log into the BIOS Setup utility with your BIOS Administrator password.
1 TPM 3 Securing screw
2 JP2 socket on motherboard
3
1
2