Filter
Top Products
3-33
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
h. On the BIOS utility screen, select the Security tab.
i. Scroll down to TPM and select TURN ON.
j. Press F10 to save your settings and reboot the server.
k. Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
l. Log into the BIOS Setup utility with your BIOS Administrator password.
m. Verify that the TPM is now enabled. Select the Security tab. Verify that the TPM entry now says
Enabled.
Replacing a PCIe Riser Card Assembly
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and then scroll to Technical Specifications:
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
To replace a PCIe riser card assembly, follow these steps:
Step 1 Remove a PCIe riser card:
a. Power off the server as described in the “Shutting Down and Powering Off the Server” section on
page 3-7.
b. Disconnect all power cords from the power supplies.
c. Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
Caution If you cannot safely view and access the component, remove the server from the rack.
d. Remove the top cover as described in the “Removing and Replacing the Server Top Cover” section
on page 3-9.
e. Remove the screw that holds the riser card assembly to the rear of the chassis (see Figure 3-21).
f. Lift the assembly and any attached PCIe cards straight up and out of the chassis. Lift up on both
ends of the bracket evenly to avoid damaging the sockets or the riser cards.
g. Remove any PCIe card from the riser card assembly and set it aside.
Step 2 Install a PCIe riser card:
a. Replace any PCIe card in the new riser card assembly.
b. Set the assembly in place, aligning the riser cards with the PCIe slots on the motherboard.
c. Press down evenly on both ends of the assembly to fully engage the riser cards with the PCIe slots
on the motherboard.
d. Replace the screw that secures the assembly to the chassis.
e. Replace the top cover.
f. Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the Power button.