Filter
Top Products
3-42
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
Replacing an LSIiBBU08 BBU
This BBU is supported by Cisco for use with the following RAID controller cards:
• LSI MegaRAID 9260-4i (Cisco product ID R200-PL004, LSI 6G MegaRAID 9260-4i
card w/512MB write cache)
• LSI MegaRAID 9280-4i4e (Cisco product ID UCSC-RAID-C-4i4e, LSI 9280-4i4e)
• LSI MegaRAID 9260-8i (Cisco product ID RC460-PL001, LSI 6G MegaRAID 9260-8i
(C200 SFF only))
To install the LSIiBBU08 BBU, you must replace the mounting bracket on the fan tray with a special
adapter bracket that is included with the BBU. Use the following procedure to replace the bracket and
to install the BBU.
Step 1 Replace the mounting bracket—only if you are replacing an LSIiBBU06 with an LSIiBBU08.
Skip this step and go to Step 2 if your server is already using an LSIiBBU08 BBU and it already has the
new mounting bracket.
a. Remove any existing BBU from the existing bracket by removing the BBU retaining screws.
b. Disconnect the RAID controller-to-BBU cable from the old BBU.
c. Remove the three screws that hold the bracket to the standoffs on the fan tray (see Figure 3-25).
d. Set the new bracket in place and replace the three screws that secure it to the fan tray (see
Figure 3-26).
Figure 3-25 Replacing a Mounting Bracket for the LSIiBBU08 BBU
331001
Mounting
bracket