Filter
Top Products
2-15
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
OL-7677-04
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in Figure 2-11.
Warning
Suitable for mounting on and over a concrete or other non-combustible surface only.
Statement 345
Figure 2-11 Mounting the Switch on a Wall
After the switch is mounted on the wall, you need to do these tasks to complete the installation:
• Power on the switch. See the “Verifying Switch Operation” section on page 2-5.
• Connect to a 10/100 port or to the RJ-45 connector of a dual-purpose port, and run the Initial
Configuration Dialog. See the Cisco ME 3400 and ME 2400 Ethernet Access Switches Getting
Started Guide for instructions.
• Connect to the front-panel ports. See the “Connecting to the 10/100 and 10/100/1000 Ports” section
on page 2-20 and the “Connecting to SFP Modules” section on page 2-21 to complete the
installation.
For configuration instructions about using the CLI setup program, go to Appendix D, “Configuring the
Switch with the CLI-Based Setup Program.”
1 User-supplied screws
132673
C
a
t
a
l
y
s
t
3
7
5
0
S
E
R
I
E
S
13
X
1
4
X
S
Y
S
T
2
X
2X
1
1