Filter
Top Products
D-4
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
OL-7677-04
Appendix D Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
end
Step 10 These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by
selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. If
you want to change this configuration or want to perform other management tasks, use the CLI.
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, see the switch software
configuration guide or the switch command reference.
If you are using a Cisco ME 3400-12CS switch with a single power supply, enter the no power-supply
dual global configuration command so that the switch does not send an alarm that the second power
supply is not operating.