Filter
Top Products
7
Chapter 2: Setting up the Hardware
Step 1: Install the Disk Drives
Getting Started Guide
Chapter
2
Part A: Set up the Hardware
This chapter provides details for installing the NSS hardware. The installation is broken down into
the following steps:
1. Step 1: Install the Disk Drives: If your NSS does not have disk drives already installed, follow
the steps in this section to insert disk drives into the NSS chassis.
2. Step 2: Connect the Ethernet Cable(s): Connect up to two Ethernet links from the NSS to your
network.
3. Step 3: Connect the Power: Ensure you have connected the power cable from the NSS to the
applicable power source (UPS or mains).
Step 1: Install the Disk Drives
After you remove the NSS from the packaging, you are ready to set up the hardware. For the
NSS6100 or NSS4100, skip this step and go to Step 2 to install the Ethernet cable(s).