Filter
Top Products
Chapter 6 Maintaining the Router
Removing and Replacing the Blower Module
6-10
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Use the following procedure to remove and replace the blower module.
Step 1 Remove the blower module from the chassis (Figure 6-5):
a. Lift the blower module handle to its carrying position.
b. Loosen the four captive screws on the blower module faceplate.
c. Remove the blower module by grasping it on each side and pulling it straight
back from the chassis.
Figure 6-5 Removing the Blower Module
1 Carrying handle 2 Captive screws (2 on each side)
129401
H
IG
H
S
P
EE
D
B
LO
W
E
R
21