Filter
Top Products
5-4
Cisco 7600 Series Ethernet Services Plus Line Card Hardware Installation Guide
OL-16146-10
Chapter 5 Installing and Removing SFP and XFP Modules
Removing and Installing SFP Modules
Step 2 Close the bale clasp before inserting the SFP module.
Step 3 Line up the SFP module with the port and slide it into the port. (See Figure 5-3.)
Figure 5-3 Installing a Bale Clasp SFP Module into a Port
Note Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line
card by firmly pushing on each SFP module. If the SFP module is not completely seated and secured in
the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into the
hole in the receptacle.
Mylar Tab SFP Module
The mylar tab SFP module has a tab that you pull to remove the module from a port. (See Figure 5-4.)
Figure 5-4 Mylar Tab SFP Module
Removing a Mylar Tab SFP Module
To remove this type of SFP module, follow these steps:
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
7600-ES+20G3CXL
ETHERNET SERVICES MODULE
STATUS
EXT CLK
1
2
3
5
7
9
4
6
8
10
7600-ES+20G3CXL
STATUS
EXT CLK
1
2
3
5
7
9
4
6
8
10
280864
63065