Filter
Top Products
5-5
Cisco 7600 Series Ethernet Services Plus Line Card Hardware Installation Guide
OL-16146-10
Chapter 5 Installing and Removing SFP and XFP Modules
Removing and Installing SFP Modules
Step 2 Disconnect and remove all interface cables from the ports; note the current connections of the cables to
the ports on the line card.
Step 3 Pull the tab gently in a slightly downward direction until it disengages from the port, then pull the SFP
module out. (See Figure 5-5.)
Figure 5-5 Removing a Mylar Tab SFP Module
Step 4
Place the removed SFP module on an antistatic mat, or immediately place it in a static shielding bag if
you plan to return it to the factory.
Step 5 Protect your line card by inserting clean SFP module cage covers into the optical module cage when
there is no SFP module installed.
Caution When pulling the tab to remove the SFP module, be sure to pull in a straight outward motion so you
remove the SFP module from the port in a parallel direction. Do not twist or pull the tab, because you
might disconnect it from the SFP module.
Installing a Mylar Tab SFP Module
To install this type of SFP module, follow these steps:
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Line up the SFP module with the port, and slide it into place. (See Figure 5-6.)
7600-ES+20G3CXL
ETHERNET SERVICES MODULE
STATUS
EXT CLK
1
2
3
5
7
9
4
6
8
1
0
7600-ES+20G3CXL
STATUS
EXT CLK
1
2
3
5
7
9
4
6
8
1
0
STATUS
280860