Cisco Systems OL-16146-10 Network Card User Manual


 
6-8
Cisco 7600 Series Ethernet Services Plus Line Card Hardware Installation Guide
OL-16146-10
Chapter 6 Troubleshooting
Packing a Cisco 7600 ES+ Line Card for Shipment
Packing a Cisco 7600 ES+ Line Card for Shipment
This section provides step-by-step instructions for packing a Cisco 7600 Series ES+ line card for
shipment. Before beginning this procedure, you should have the following original Cisco Systems
packaging materials:
Static shielding bag
Smaller inner carton
Larger exterior carton
Two foam packing cushions
Caution The Cisco Systems original packaging is to be used for the shipment of all Cisco 7600 Series ES+ line
cards. Failure to properly use Cisco Systems packaging can result in damage or loss of product.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Note These instructions assume that the Cisco 7600 Series ES+ line card has been removed from the router
according to the recommended procedures specified in this guide.
To pack a Cisco 7600 Series ES+ line card for shipment, perform the following steps:
Step 1 Insert the Cisco 7600 Series ES+ line card into the static shielding bag.
Step 2 Insert the bagged Cisco 7600 Series ES+ line card into the smaller inner carton. Be careful to position
the Cisco 7600 Series ES+ line card so that the bottom motherboard lip is held by the packaging cutout.
Step 3 Close the smaller inner carton and tape the sides closed.
Step 4 Place the sealed smaller inner carton containing the Cisco 7600 Series ES+ line card into the two foam
packing cushions (they only fit one way).
Step 5 Place the sealed smaller inner carton and packing cushions into the larger exterior carton, and seal the
larger exterior carton with tape for shipment.