Filter
Top Products
2-4
Cisco 7600 Series Ethernet Services Plus Line Card Hardware Installation Guide
OL-16146-10
Chapter 2 Overview: Cisco 7600 Series Ethernet Services Plus Line Cards
Identifying Slots and Subslots for the Cisco 7600 Cisco 7600 Series ES+ Line Cards
Note The Cisco 7600 Series ES+ line cards are not supported with a Supervisor Engine 1, Supervisor
Engine 1A, Supervisor Engine 2, Supervisor Engine 720-3A, or Supervisor Engine 32.
For information about the chassis slots available in different Cisco 7600 series router models, see
http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/hardware/cis_76xx/osr_over.htm.
Some commands allow you to display information about the Cisco 7600 Series ES+ line card itself, such
as show module, show idprom module, show hw-module slot, and show diagbus. These commands
require you to specify the chassis slot location where the Cisco 7600 Series ES+ line card that you want
information about is installed.
For example, to display status and information about the Cisco 7600 Series ES+ line card installed in
slot 10 of a Cisco 7609 router, enter the following command:
Router# show module 10
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
10 20 7600 ES+ 7600-ES+20G3CXL JAE1151865I
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
10 001d.e5e8.2a00 to 001d.e5e8.2a3f 0.301 12.2(33r)SRD 12.2(nightly Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
10 7600 ES+ DFC XL 7600-ES+3CXL JAE115188YM 0.200 Ok
10 7600 ES+ 20xGE SFP 7600-ES+20G JAE1151860R 0.301 Ok
Mod Online Diag Status
---- -------------------
10 Pass
Router#
For more information about Cisco 7600 Series ES+ line card commands, see the Cisco IOS Software
Releases 12.2 SR Command References.
Note The Cisco 7600 Series ES+ line card must be in a slot that provides two primary serial channels. Dual
serial channels are not available in all slots of a 13-slot chassis. Dual fabric connectivity is supported in
slots 9 to 13.
Cisco 7600 ES+ Line Card Slot, Bay, and Port Locations
The Cisco 7600 Series ES+ line card uses a <slot, port> numbering scheme. The slot refers to whichever
slot the line card occupies in the router. The port numbering begins at 1 on all versions of the Cisco 7600
Series ES+ line card. The upper limit depends on the card type. This physical port numbering is reflected
in CLI messages and all references to port numbers that are visible to the user.
Executing the show interface command for a Cisco 7600 Series ES+ line card located in slot 10 of a
Cisco 7600 series router chassis produces the following (only first six interfaces are shown):
Router# show interfaces gigabitEthernet 10/2
GigabitEthernet10/2 is up, line protocol is up (connected)
Hardware is X40G 1Gb 802.3, address is 000f.35c2.ec00 (bia 000f.35c2.ec00)
Description: connect to test 7/2
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,