Filter
Top Products
5-8
Cisco 7600 Series Ethernet Services Plus Line Card Hardware Installation Guide
OL-16146-10
Chapter 5 Installing and Removing SFP and XFP Modules
Removing and Installing SFP Modules
Installing an Actuator Button SFP Module
To install this type of SFP module, follow these steps:
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Line up the SFP module with the port and slide it in until the actuator button clicks into place. (See
Figure 5-9.) Be sure not to press the actuator button as you insert the SFP module because you might
inadvertently disengage the SFP module from the port.
Figure 5-9 Installing an Actuator Button SFP Module
Note Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line
card by firmly pushing on each SFP module. If the SFP module is not completely seated and secured in
the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into the
hole in the receptacle.
Slide Tab SFP Module
The slide tab SFP module has a tab underneath the front of the SFP module that you use to disengage
the module from a port. (See Figure 5-10.)
Figure 5-10 Slide Tab SFP Module
7600-ES+20G3CXL
ETHERNET SERVICES MODULE
STATUS
EXT CLK
1
2
3
5
7
9
4
6
8
10
7600-ES+20G3CXL
STATUS
EXT CLK
1
2
3
5
7
9
4
6
8
10
280862
84651