Filter
Top Products
1-14
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
OL-8794-05
Note The 2 front holes should match up with the top and bottom holes of the rail front flange.
All holes should correspond to the rail mounting positions (i.e., the holes marked with pen or tape).
Step 2 Fasten the rail back flange (chassis leaf module side) to the rack by installing two screws into the rail
and rack.
Figure 1 Rail Back Flange
Step 3 Fasten the rail front flange (chassis fan side) to the rack by installing one screw into the top hole of each
rail.
Figure 2 Rail Front Flange
Install the second rail on the other side of the rack by repeating steps 1 through 3.
Rack-Mount the Switch
Caution Because of its size and weight, it is recommended that either a lifting device or three (3) people install
the SFS 7024.
To install the switch into the rack, perform the following steps:
Step 1 Clear the area of any unnecessary materials.
Step 2 Attach the clip of the ESD wristband (strap) to bare metal on the cabinet. Put the wristband around one
wrist with the metal button against the skin.
Install 2 screws to
top and bottom holes
Install 2 screws to
o
p and bottom holes