Filter
Top Products
Chapter 5
Configuration Using the Web-based Utility
47
24/48-Port 10/100 + 4-Port Gigabit Smart Switch with Resilient Clustering Technology and PoE
Admin > Firmware Upgrade
Admin > Firmware Upgrade
The Firmware Upgrade screen allows you to download
firmware upgrade files from a TFTP server, or from your
computer via the HTTP interface.
Via TFTP Select this to download from or upload to a
TFTP server. When you select this option, the following
fields are displayed.
UPGRADE Select this option to upgrade the switch
from a file located on a TFTP server.
File Type Select the type of file to download,
either Software Image or Boot Code.
TFTP Server Enter the TFTP Server IP Address that
contains the source file to upgrade from.
File Name Enter the name of the upgrade file on
the TFTP Server.
BACKUP To back up the firmware to a TFTP server,
enter the TFTP server address.
TFTP Server Enter the TFTP Server IP Address to
which the firmware file will be saved.
File Name Displays the name of the firmware file.
This field cannot be edited.
Via HTTP Select this to download an upgrade file using
the HTTP interface. When you select this option, the
following field is displayed:
Source File Enter the name and path of the file or
click Browse to locate the upgrade file.
Click Save Settings to begin the download or upload.
Admin > Reboot
The Reboot screen is used to reset one Switch or the entire
stack. From the drop-down menu, select the unit number
or Stack, then click Reboot, then click OK to confirm. The
configuration settings are automatically saved before the
system reboots.
•
•
•
•
•
•
•
•
Admin > Reboot
Admin > Factory Default
The Factory Default screen allows network managers to
reset the Switch to the factory defaults shipped with the
switch. This results in erasing the configuration file.
NOTE: Restoring factory defaults erases all
current configuration settings. You can save a
copy of your configuration settings beforehand
using the Admin > Save Configuration screen.
Admin > Factory Default
To restore the factory defaults, click Restore Default, then
click OK to confirm. Then restart the Switch by going to
the Admin > Reboot screen; once there, select the master
unit number (if applicable), click Reboot, then click OK.