Filter
Top Products
22
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
OL-5078-01
Dual-Width Port Adapter
Dual-width port adapters occupy both port adapter slots on a VIP6-80. Before you can install a
dual-width port adapter, first remove the slot divider located between the two port adapter slots. (See
Figure 6.) Refer to Table 4 for a list of dual-width port adapters.
Figure 6 Location of VIP6-80 Slot Divider and Screws
Use the following procedure to remove the slot divider from a VIP6-80:
Step 1 Use a number 1 Phillips screwdriver to remove the screw located at the rear of each port adapter slot (see
Figure 7).
Step 2 Remove the four slot divider screws that secure the slot divider to the VIP6-80 motherboard. (See
Figure 6.)
Step 3 Remove the slot divider and store it (and the screws) in a location where you can retrieve it for use later.
Note If you need to reinstall the port adapter slot divider, place the slot divider in position on the VIP6-80 and
secure it with the four Phillips screws.
Step 4 See Figure 7 for the steps to install or remove a dual-width port adapter.
27871
Screw holes for septum