Filter
Top Products
Configuration
21
WAN Status – PPPoE
Figure 12: WAN Status – PPPoE
Status Data
WAN Status
Physical Address
The "Hardware" address of this device, as seen by other devices on the
WAN.
IP Address
The IP Address of this device, as seen by devices on the WAN.
(This device has 2 IP Addresses; one for the local LAN, and another
for the WAN port.)
Network Mask
The Network Mask (Subnet Mask) for the IP Address above.
PPPoE Link
Status
This indicates whether or not the connection is currently established.
If the connection does not exist, the
Connect
button can be used to
establish a connection.
If the connection currently exists, the
Disconnect
button can be used to
break the connection.
Connection Log
Log Data
The Connection Log shows status messages relating to the existing
connection.
The most common messages are listed in the following table.
Buttons
Connect
If not connected, establish a connection to your ISP
Disconnect
If connected to your ISP, hang up the connection.
Clear Log
Delete all data currently in the Log. This will make it easier to read new
messages.