Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-3
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Writer:
Chris Seiter
Project:
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Comments:
ile Name:
2824_5.DOC
Last Saved On:
06/25/97 5:32 PM
SNMP Management
The 2824 hub supports SNMP management through both in-band and out-of-
band communications. In-band management support is provided by SNMP over
IP and IPX protocol stacks and VT100 emulation over Telnet (TCP/IP). Out-of-
band management support is provided by SNMP over SLIP and through direct
serial interfaces using VT100 emulation. The 2824 hub stores management
configuration information in Non-Volatile RAM (NVRAM), which helps
protect the configuration from a power outage. See “Parameters Stored in
NVRAM.”
Supported MIBs
The 2824 hub supports the following standard MIBs under SNMP, which
determine what management functions it can perform:
■
RFC1213 (MIB II) Management Information Base for Network
Management of TCP/IP-based Internets (MIB II)
■
RFC1516 Definitions of Managed Objects for the IEEE 802.3
Repeater Devices (technically part of MIB II)
■
RFC1757 (RMON) Remote Network Monitoring Management
Information Base (RMON MIB)
■
HUBNVLE Novell Ethernet Repeater MIB
■
CPQN2FE Compaq Netelligent 2000 Fast Ethernet MIB
■
CPQNUNIF Compaq Netelligent Unified MIB
Supported Frame Types
The hub supports four different Ethernet frame types. It is important to know
that the 2824 hub supports the frame types used in your network. For
convenience, each frame type is referred to by its Novell name. The following
table lists each frame type, its Novell name, and whether or not it is supported
for IP and IPX.