Filter
Top Products
Maintenance and Service Guide 8-27
Configuration Switch Bank SW3
If the SW3 switches are present, they are
reserved and should be set to the OFF position.
Jumper P1 Settings for the COMPAQ
Enhanced Color Graphics Board
The setting for Jumper P1 is determined by the
monitor used with the COMPAQ Enhanced
Color Graphics Board (Figures 8-13 and 8-14).
To reset the jumper, remove the jumper from
its current pins and press it into place on the
correct pins.
Jumper JP3 Setting for the COMPAQ
Enhanced Color Graphics Board
Pin 1-2 is the standard factory setting. Do not
change this setting.
Figure 8-13. Setting for a COMPAQ Color or Compatible
Enhanced Color Monitor.
Figure 8-14. Setting for an RGBI Color Monitor or a
COMPAQ Dual-Mode Monitor.