Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-4
Setup and Configuration
Writer:
Weldon W. Rowan
Project:
Setup and Configuration
Comments:
File Name:
SAB_3.DOC
Last Saved On:
7/2/98 4:53 PM
To start the Compaq HB1004 System
Configuration Program from
Windows:
1. Insert the Compaq HB1004 Configuration Program diskette into the
floppy disk drive
2. In File Manager or Program Manager, click File, then click Run
3. Type A:\HB1004CP for Drive A or B:\HB1004CP for Drive B
in the Command Line box
4. Click the OK button to open the program and display the
communication dialog box shown in Figure 3-3.
NOTE
: The Compaq HB1004 System Configuration Program allows selection of
COM Ports 1, 2, 3 or 4 and assumes the normal default IRQ for the appropriate
port (i.e. COM1 is IRQ4, COM2 is IRQ3, COM3 is IRQ4 and COM4 is IRQ3). If
your communication port is configured differently, it is necessary to specify the
correct IRQ for that port. If this is the case, type:
A:\HB1004CP /i[irq#] or B:\HB1004CP /i[irq#]
In the
C
ommand Line box.
To start the Compaq HB1004 System
Configuration Program from
Windows 95 or Windows 98:
1. Insert the Compaq HB1004 Configuration Program diskette into the
floppy disk drive
2. Click the Start button in the lower left corner of the screen
3. Click Run...
4. Type A:\HB1004CP for Drive A or B:\HB1004CP for Drive B
in the Open box
5. Click the OK button to open the program and display the
communication dialog box shown in Figure 3-3.