Filter
Top Products
Installation
2-11
Compaq Confidential – Need to Know Required
Writer:
Dan Lyons
Project:
Compaq R6000 Series UPS Operation and Reference Guide
Comments:
revised as per A. May
Part Number:
347223-022
File Name:
c-ch2.doc
Last Saved On:
3/24/99 1:41 PM
NORMAL BYPASS
138425244-001 REV. P00
1
&
4
2
14235
555
3322
231
11
444
3
Figure 2-5. Removing terminal input block cover
3.
Remove the input wiring entry port cover.
4.
Pull the input wires through the conduit leading from the AC Mains,
leaving about 2 ft (0.5 m) of wire hanging from the end. Attach a
suitable connector to the end of the conduit.
5.
Feed the wires through the wiring entry port, the entry compartment and
the terminal input block compartment.
6.
Connect the conduit to the panel. Measure wires, cut and strip 0.5 inch
(1¼ cm) of insulation from the end of each incoming wire.
7.
Following the diagram on the input cover, connect the input wires to the
input terminal block connections and Ground. Ensure no loose strands
remain and that the terminal connection screws are tightened to torque
specifications found on the label immediately below the terminal block.