Filter
Top Products
Configuration
4-15
Compaq Confidential – Need to Know Required
Writer:
Daniel E. Lyons
Project:
Compaq R6000 Series UPS Operation and Reference Guide
Comments:
Revised as per A. May
Part Number:
347223-022
File Name:
e-ch4.doc
Last Saved On:
3/24/99 1:44 PM
System Setup
To change the system setup, the correct password must be entered. The six
digits for the password [0-9 & A-Z] are selected using the Center and Enter
buttons.
1.
Choose the first digit using the Center button’s UP and DOWN arrow
keys.
2.
Press the Center button’s RIGHT arrow key to move to the next digit.
3.
To change a digit, use the Center button’s LEFT arrow key to go back.
4.
After the entire password has been entered, press the Enter button.
NOTE:
The password must be six characters long. The default password is “COMPAQ.”
To establish or change the password, see “Set Password,” later in this chapter.
Enter Password
COMPAQ
IMPORTANT:
The Password must be six characters in length. Once entered, record the
password. If the password is forgotten or lost, contact an authorized Compaq Service
Provider.
Set Hardware (HW) Configuration
Load Segments
This Submenu provides a means to specify the number of
individually-controllable load segments (from 1 to 5).
Set HW Config
→ Load Segments
By pressing the Enter button, this Submenu appears
Load Segments
(0-5)