Filter
Top Products
Introduction
Service Information S260-75-1 provides installation,
operation, and maintenance instructions for the Kyle
®
Type S automatic load-transfer control.
Read This Manual First
Read and understand the contents of this manual and
follow all locally approved procedures and safety prac-
tices before installing or operating this equipment.
Additional Information
These instructions cannot cover all details or variations in
the equipment, procedures, or process described, nor to
provide directions for meeting every possible contin-
gency during installation, operation, or maintenance. For
additional information, contact your Cooper Power
Systems representative.
Acceptance and Initial
Inspection
Each Type S control is completely assembled, tested,
and inspected at the factory. It is carefully calibrated,
adjusted, and in good condition when accepted by the
carrier for shipment.
Upon receipt, inspect the carton for signs of damage.
Unpack the control and inspect it thoroughly for damage
incurred during shipment. If damage is discovered, file a
claim with the carrier immediately.
Handling and Storage
Use care during handling and storage of the control. If
the control is to be stored for any length of time prior to
installation, provide a clean, dry storage area to mini-
mize the possibility of mechanical damage.
ANSI Standards
Kyle reclosers are designed and tested in accordance
with ANSI standards C37.60 and C37.85 and ANSI
guideline C37.61.
Quality Standards
The Quality System at the Cooper Power Systems, Kyle
Distribution Switchgear plant is
ISO 9001 certified.
ISO 9001
CAN/CSA ISO 9001
BS EN ISO 9001
ANSI/ASQC Q9001
S260-75-1
3
!
SAFETY
FOR LIFE
PRODUCT INFORMATION