Filter
Top Products
infiNET™ Switches Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF
Industry Canada Statement
The term "IC" before the certification/registration number only signifies that the
Industry Canada technical specifications were met.
IC: 5683A-CWD1011
Acquiring the Switch on the infiNET Network
Before an infiNET device can be used on an infiNET network, it must first be
acquired to a C2N-MNETGW gateway that is connected to a Cresnet network.
NOTE: The -SW1RF, -SW4RF, -SWS1RF, and -SWS4RF can also work as stand-
alone wall box switches without being acquired by a C2N-MNETGW.
NOTE: A switch can be acquired to only one gateway.
Acquiring the Switch
To acquire a -SW1RF/-SW4RF/-SWS1RF/-SWS4RF to C2N-MNETGW, perform
the following:
1. Put the C2N-MNETGW in the Acquire mode, from the unit itself or from
Toolbox, as described in the latest revision of the C2N-MNETGW
Operations Guide (Doc. 6137), which is available from the Crestron
website.
NOTE: In an environment where multiple gateways are installed, only one
gateway should be in the Acquire mode at a time.
2. Place the -SW1RF/-SW4RF/-SWS1RF/-SWS4RF into the Acquire mode by
doing the following:
a. Move the mode selection switch (located under the LED) to the
“OFF” position.
b. Press and hold the top or bottom of the button on the -SW1RF/
-SWS1RF or any button on the -SW4RF/-SWS4RF.
c. While holding the button, slide the mode selection switch to the
“RUN” position.
d. Hold the button for approximately five seconds until the LED
flashes HIGH once. Immediately release the button after the LED
blinks to start the dimmer’s Acquire mode.
NOTE: The LED can flash HIGH or LOW. Refer to “LED Behavior” on
page 11 for more information.
NOTE: Holding the button for a significant time after the first flash may
enter other modes. If this is not desired, return the mode selection switch to
the “OFF” position without releasing the button and repeat step 2.
After approximately ten seconds, the LED will start to blink slowly and the
switch will attempt to acquire with a C2N-MNETGW that is in the Acquire
8 • infiNET Switches: Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF Operations Guide - DOC. 6397