Data Editing
116 Gryphon™ I GD4100
Label ID — continued
Table 18
STEP ACTION EXAMPLES
1. Scan the ENTER/EXIT
barcode
(Scanner enters Programming Mode)
2. Determine placement of
the Label ID characters
BEFORE or AFTER with
regard to scanned data
using Label ID Control, starting
on page 117
Enable as Prefix Enable as Suffix Enable as Prefix Enable as Suffix
3. Scan the barcode selecting
the symbology type you
wish to designate label ID
characters for using Label ID
Symbology Selection, starting on
page 118.
DataBar
Omnidirectional
Code 39
Interleaved 2 of 5 Code 32
4. Custom Label ID example
(desired characters):
D B * = C 3 +P H
5. Find hex equivalents from
the ASCII table (inside back
cover), then scan in these
digits/characters using the
barcodes in the section:
Keypad, starting on page 301. If
you make a mistake before
the last character, scan the
CANCEL barcode to abort
and not save the entry
string. You can then start
again at the beginning.
44 42 2A 3D 43 33 2B 50 48
6. Scan the ENTER/EXIT
barcode
(Scanner exits Label ID entry)
7. Scan the ENTER/EXIT
barcode once again
(Scanner exits Programming Mode)
Result:
DB*[barcode data]
[barcode
data]=C3
+[barcode data] [barcode data]PH
. Label ID Examples