Filter
Top Products
INDICATION DESCRIPTION LED BEEPER
Power-up Beep
The reader is in the process of pow-
ering-up.
Reader beeps four times at highest
fr
eq
uency and volume upon power-
up.
Good Read Beep
A label has been successfully
scanned
b
y the reader.
LED behavior for this indica-
tion is configurable via the
fea
ture “
Good Read: When
to Indicate
”
The reader will beep once at current
fre
quency, volume, mono/bi-tonal
setting and duration upon a suc-
cessful label scan.
ROM Failure
There is an error in the reader's soft-
ware/programming
Flashes
Reader sounds one error beep at
hi
ghe
st volume.
Limited Scanning
Label Re
ad
Indicates that a host connection is
not es
tablished when the IBM or
USB interface is enabled.
N/A
Reader 'chirps' six times at the high-
est frequency and current volume.
Reader Active
Mode
The reader is active and ready to
scan.
T
he LED is lit steadily
a
a. Except when in sleep mode or when a Good Read LED Duration other than 00 is selected
N/A
Reader
Disabled
The reader has been disabled by the
hos
t
.
The LED blinks continuously N/A
Green Spot is on
c
o
ntinuously
While in Stand Mode or Trigger
Stand Mode
the green spot shall be
on while in stand watch state.
N/A N/A
Green Spot
a
flashes
momentarily
Upon successful read of a label, the
soft
ware shall turn the green spot
on for the time specified by the con-
figured value.
N/A N/A
Programming Mode - T
h
e following indications ONLY occur when the reader is in Programming Mode.
Label Program-
ming Mode Entry
A valid programming label has been
scanned.
LED blinks continuously
Reader sounds four low frequency
b
eeps.
Label Program-
ming Mode Rejec-
tion of Label
A label has been rejected. N/A
Reader sounds three times at low-
est frequency & current volume.
Label Program-
ming Mode Accep-
tance of Partial
Labe
l
In
cases where multiple labels must
be scanned t
o
program one feature,
this indication acknowledges each
portion as it is successfully scanned.
N/A
Reader sounds one short beep at
hi
ghe
st frequency & current vol-
ume.
Label Program-
ming Mode Accep-
tance of
Pr
ogramming
Configuration option(s) have been
succes
sfu
lly programmed via labels
and the reader has exited Program-
ming Mode.
N/A
Reader sounds one high frequency
b
eep
and 4 low frequency beeps
followed by reset beeps.
Label Program-
ming Mode Cancel
Item
Entry
Cancel label has been scanned. N/A
Reader sounds two times at low fre-
quency and current volume.
LED and Beeper Indications
286 Gryphon™ I GD4100
LED and Beeper Indications