Filter
Top Products
Getting Started
12 Gryphon™ I GD4100
Install the Interface Cable
Connect the reader cable by inserting the cable into the handle as shown in Figure 1. To remove
it, insert a paper clip into the release aperture
, then unplug the cable.
Figure 1. Connect/disconnect the cable
RS-232 Serial Connection
Turn off power to the terminal/PC and connect the reader to the terminal/PC serial port via the
RS-232 cable as shown in Figure 2. If the terminal will not support POT (Pow
er Off the
Terminal) to supply reader power, use the approved power supply
(AC Adapter). Plug the AC
Adapter barrel connector into the socket on the RS-232 cable connector and the AC Adapter
plug into a standard power outlet.
Figure 2. RS-232 Connection