Filter
Top Products
Removing the Hard Drive 41
To replace the hard drive in the hard drive bay:
1
Follow the procedures in "Before You Begin" on page 39.
2
Turn the computer over, unscrew the hard-drive cover screws, and remove the cover.
3
Remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging.
See "Protecting Against Electrostatic Discharge" in the Product Information Guide.
4
Slide the hard drive out of the computer.
5
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may
damage the connector.
6
Slide the hard drive into the bay until it is fully seated.
7
Replace and tighten the screws.
8
Install the operating system for your computer.
9
Install the drivers and utilities for your computer.
hard drive
cover
hard drive screws (2)
hard drive
hard drive cover
screws (2)