Filter
Top Products
Precautions
Service Manual
5-13
12. Pull up the CCD Shaft and take out the CCDM.
13. Squeeze the spring to release the tension in the Belt
and lift from the pulleys, as shown below.
14. Remove the three screws securing the Scan Motor
Ass'y and remove it.
15. If necessary, remove the two screws securing the
Scan Motor and remove it, as shown below.
Caution : Reassembling CCDM
1) When refitting the Scanner Belt and Belt Spring take
care to relocate the tension spring as close to the right
side of the CCDM as is possible, as shown below.
2) When refitting the Scan Upper Cover take care to
ensure that the Cover Open Switch is not trapped.
CCDM
CCD Shaft
Scan Motor Ass'y
Scan Motor
Gear Bracket Ass'y
Belt
Spring