Filter
Top Products
Alignment & Adjustments
Service Manual
6-23
Display Meaning Suggested solutions
Memory Full The memory is full. Delete unnecessary documents,
Cancel or Start retransmit after more memory becomes
available.
Memory Full The memory is full. Split the transmission into more than
Divide the Job one operation.
No Answer Try Later The remote fax machine has not answered Try again. Verify the number to make
after several redial attempts. sure a fax can be received.
No Cartridge The toner cartridge is not installed. Install the toner cartridge. See
Load Cartridge "Installing the Toner Cartridge".
No Paper The paper in the paper tray has run out. Load paper in the paper tray. See
Add Paper "Loading Paper".
No such job You are performing an Add/Cancel Check the display to see if there are
operation, but there are no jobs waiting. any scheduled jobs. The display should
indicate if any scheduled jobs are in
Standby mode, for example, Delay Fax.
Over Heat There is a problem in the fuser unit. Unplug the power cord and plug it back
Call Service in. If the problem persists, call for service.
Open Heat Error Call There is a problem in the fuser unit. Unplug the power cord and plug it back
Service in. If the problem persists, call for service.
Paper Jam 0 Paper has jammed in the feeding area Clear the jam. See "Paper Feed Jam
Open Front Door of the paper tray. (tray 1)" or "Paper Feed Jam (optional
tray 2)".
Paper Jam 1 Paper has jammed in the fuser area. Clear the jam. See "Fuser Area Jam".
Cartridge Area
Pager Jam 2 Paper has jammed in the paper exit area. Clear the jam. See "Paper Exit Jam".
Open Rear Door
Power Failure The power has been turned off and then The printer's memory was not saved
Data Lost on and the printer's memory has not been due to a power failure. The job will
saved. need to be started over.
Printer Error Cycle Power A problem has occurred in the Laser Unplug the power cord and plug it back
Scanning Unit (LSU). in. If the problem persists, call for service.
Ready-toner 0% The toner cartridge is empty. Replace the toner cartridge with a new
TONER EMPTY one. See "Replacing the Toner Cartridge".
Ready-toner 7% The toner cartridge is almost empty. Take out the toner cartridge and
TONER LOW thoroughly shake it. By doing this, you
can temporarily reestablish printing
operations.
OR
Replace the toner cartridge with a new
one for the best print quality. See
"Replacing the Toner Cartridge".
Scanner locked The scanner module is locked. Unlock the scanner and press Start.
Unlock scanner
Self Diagnostic The engin in your printer is checking Please wait a few minutes.
some problems detected.
Waiting for redial The machine is waiting for the Please wait a few minutes.
programmed interval to automatically
redial.