Filter
Top Products
Service Manual
Precautions
5-18
1. Before you remove the Shield Controller Ass'y, you
should remove:
- Rear Cover (Refer to 5.4)
- Side Cover Left (Refer to 5.6.4)
2. Unplug the all connectors and remove the one screw
securing the Ground Cable.
3. Remove the five screws securing the Shield Controller
Ass'y and remove it.
4. Remove the three screws securing the Main PBA to
the Bracket and unplug the Film Cable and then
remove the Main PBA.
5. The connectors are located, as shown below.
5.10 Shield Controller Ass'y
Shield
Film Cable
Main PBA
ADF Flat Motor
Flat Cover
CCD
OPE Panel
USB Host
Cartridge
USB
Line
Modem PBA
Duplex Motor
Engine
BLDG
Pick Up
REGI
LSU_5V
LSU
Thermo
MPF_SEN
MPF
Network
USB
Tray2
Shield Controller Ass'y