Filter
Top Products
Processor 75
Replacing the Processor
Procedure
1
Unpack the new processor, being careful not to touch the underside
of the processor.
CAUTION: Ground yourself by touching an unpainted metal surface.
CAUTION: You must position the processor correctly in the processor socket to
avoid permanent damage to the processor.
2
If the release lever on the socket is not fully extended, move it to
that position.
3
Orient the alignment notches on the processor with the alignment tabs
on the socket.
4
Align the pin-1 corners of the processor and socket, and then place the
processor in the processor socket. Set the processor lightly in the socket
and ensure that the processor is positioned correctly.
CAUTION: Ensure that the processor cover notch is positioned underneath the
alignment post.
5
When the processor is fully seated in the socket, close the processor cover.
6
Pivot the release lever down and place it under the tab on
the processor cover.
1 processor pin-1 indicator 2 processor
3 alignment notches (2) 4 alignment post
5 processor cover 6 release lever
5
3
1
2
4
6
OM_Book.book Page 75 Friday, March 30, 2012 1:21 PM