Filter
Top Products
a. Press out the securing clip at each end of the memory module connector.
b. Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
7. To insert a module, press out the securing clip at each end of the memory module connector.
8. Align the notches on the bottom of the module with the crossbars in the connector.
9. Insert the module straight down into the connector, ensuring that it fits into the vertical guides at each end of the connector. Press firmly on the ends
of the module until it snaps into place.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
10. Close the computer cover.
11. Attach the computer stand (optional).
12. Connect your computer and devices to their electrical outlets, and turn them on.
13. Right-click the My Computer icon and then click Properties.
14. Click the General tab.
15. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Replacing the AGP Card
1. Shut down the computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4. Remove the computer stand, if it is attached.
5. Open the computer cover.
6. Remove the filler bracket by raising the hinged lever and sliding the bracket up.
Press the tab on the hinged lever with your thumb until you release the tab. Continue holding the lever and pull the lever up.
NOTICE: To avoid breaking the memory module, do not press near the middle of the module.
NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.