Filter
Top Products
58 Appendix I. Regulatory statement
The user’s manual for end users must include the following information in a
prominent location "IMPORTANT NOTE: To comply with FCC RF
exposure compliance requirements, the antenna used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any
other antenna or transmitter."
EU Compliance
Regulatory compliance of the DELL5002
The DELL5002 are made for OEM integrations only. The European
regulations applying to the DELL5002 is the R&TTE Directive 1999/5/EC.
DELL5002 meets the following requirements of the R&TTE Directive.
The conformity assessment for the DELL5002 were completed in accordance
with the R&TTE Directive Annex IV procedures, and the EC Declaration of
Conformity is attached to this manual.
Cautions regarding regulatory compliance when integrating the
DELL5002
The person integrating the DELL5002 becomes the manufacturer of the final
product and is therefore responsible for demonstrating compliance of the
product with the essential requirements of the R&TTE Directive.
In all cases assessment of the final product must be made against the
Essential requirements of the R&TTE Directive Article 3.1(a) and (b), safety
and EMC respectively, and any relevant Article 3.3 requirements
This device is intended only for OEM integrators under the following
conditions:
1
This appliance and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
R&TTE Directive article Test category Harmonized standard
Article 3.1(a) Protection of health and
safety
EN 60950-1, EN 50385
Article 3.1(b) EMC EN 301 489-1/-17
Article 3.2 Effective use of the
spectrum
EN 300 328