Filter
Top Products
Appendix I. Regulatory statement 59
2
A minimum separation distance of 20 cm must be maintained between
the antenna and the person for this appliance to satisfy the RF exposure
requirements of the Council recommendation 1999/519/EC of 12 July
1999.
As long as the 2 conditions above are met, no further evaluation under Article
3.2 of the R&TTE Directive and do not require further involvement of an
R&TTE Directive Notified Body for the final product. In all other cases, or if
the manufacturer of the final product is in doubt then the equipment
integrating the radio module must be assessed against Article 3.2 of the
R&TTE Directive.
Please note that this product, DELL5002, uses radio frequency bands not
harmonized throughout the Community. This product is classified as Class 2
radio equipment for which some Member States apply restrictions on placing
on the market and in use. Any parties putting Class 2 radio equipment on the
market must notify the relevant national spectrum management authority of
their intention, and the radio equipment must be given a Class Identifier
(alert symbol).
Antenna
This product, DELL5002, is for OEM integrations only. The end-user
product will be installed in such a manner that only the authorized antennas
are used.
Enclosure
This product, DELL5002, is made for integrating in another final product.
For this reason, there are some parts of the final product on which the
DELL5002 depends for regulatory compliance regarding EMC and safety.
The DELL5002 is mounted on the circuit board of the final product, and
must be contained inside the case of the final product. Integrated the
DELL5002 in the final product so that its surfaces are not in contact with the
outside.
Documentation
In the documentation for the conformity assessment of the final product,
state clearly that the DELL5002 is integrated in the system.