Filter
Top Products
Removing and Installing Parts 141
NOTE: The location of connectors on the system board may vary depending on
your computer.See "Inside View of Your Computer" on page 109.
5
Remove the four screws securing the hard drive.
NOTICE: Ensure that you do not scratch the screw holes with the screw driver as
the hard disk circuit board assembly is exposed here.
6
Slide the drive out away from the front of the computer.
7
If removing this drive changes the drive configuration, then be sure to
reflect these changes in system setup. When you restart your computer,
enter system setup (see "System Setup" on page 187), then go to the
"Drives" section of the System Setup and under
Drive 0 through 3
, set the
Drive to the correct configuration.
1 hard drive 2 power cable 3 serial ATA data cable
4 system board connector 5 screws (4)
2
4
3
1
5
book.book Page 141 Monday, October 6, 2008 11:28 AM