Filter
Top Products
8. Remove the two shorter, green plastic rails from the inside of the computer cover.
These rails are not attached to the computer cover with screws. To remove the rails, firmly pull the rails from the drive cage.
9. Attach the rails to the drive using the screws supplied with the drive.
Ensure that the rail tabs are positioned at the back of the drive.
10. Gently slide the drive into the bay until you hear a click.
11. Carefully replace the drive bay cover.
You do not need to replace the cover insert.
12. Connect a power cable to the drive.
See the documentation that came with the drive for instructions on connecting a drive cable to the drive.
13. Close the computer cover.
14. Connect your computer and devices to their electrical outlets, and turn them on.
15. Install any drivers required for the drive as described in the documentation that came with the drive.
Replacing the Microprocessor
1. Shut down the computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device
and the device connected to the middle connector is the slave device. Be sure the jumper setting on the new device is set for "cable select" (see the
documentation that came with the drive for information).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."