Filter
Top Products
34 Getting Started
www.dell.com | support.dell.com
Loading Paper
Load Plain Paper Into the Paper Support
1 Lift the paper exit tray and extend the paper support.
2 Insert paper into the paper support.
3 Squeeze and slide the paper guides to rest against the left and right edges and bottom of
the paper.
4 Lower the paper exit tray.
5 Extend the paper exit tray stop to catch paper as it exits the printer.
NOTE: Do not force the paper into the printer.
Print Media Guidelines for the Paper Support
Follow these guidelines when loading specialty print media in the paper support.
Load up to: Make sure:
150 sheets of
plain paper
• The paper is centered in the paper support.
• The paper guides rest against the right and left edges of the paper.
NOTE: Load letterhead paper with the front of the letterhead face down, and the
top of the letterhead going into the printer first.
• The paper guide rests against the bottom edge of the paper.
•You select Draft (select Photo if a photo cartridge is installed), Normal, or Photo
print quality.
20 sheets of
banner paper
• You remove any paper from the paper support before inserting banner paper.
• You place a stack of banner paper (20 sheets or less) on the top cover of the
printer and feed in the first sheet.
NOTE: You must select A4 Banner or Letter Banner paper size in Print Properties.
Failure to do so will cause a paper jam. See "Paper Problems" on page 81.
• You load the leading edge of the banner paper into the printer against the right
side of the paper support.
• You squeeze and slide the paper guide to the left edge of the banner paper.
• You use banner paper designed for inkjet printers.